Installing Your Stickers

1.   Clean and dry the surface with paper towel.

2.   Peel backing off sticker and make sure the sticker remains stuck to front application tape.

3.   Place the sticker on the surface and squeegee or rub the sticker slowly pulling firm so that wrinkles and or bubbles are minimized or limited.

4.    Slowly peel top tape off at an angle.

5.    If bubbles are present, use a needle or xacto blade to carfully poke a small pinhole on side of bubble.
NOTE: Do not use fingernail or squeegee to push bubble out! This may damage the sticker face. Instead use your finger to roll out any trapped air.

6.    Smaller bubbles will usually dissapear with sun or heat over a short time.